Technical data

Diagnostics
5.3 Fault and alarm messages
Function Manual
Function Manual, 06/2012, 6SL3097-4AB10-0BP4
103
Overview of important parameters (see SINAMICS S110 List Manual)
Adjustable parameters
● p0771[0...1] CI: Measuring sockets signal source
● p0777[0...1] Measuring sockets characteristic value x1
● P0778[0...1] Measuring sockets characteristic value y1
● p0779[0...1] Measuring sockets characteristic value x2
● p0780[0...1] Measuring sockets characteristic value y2
● p0783[0...1] Measuring sockets offset
● p0784[0...1] Measuring sockets limit on/off
Display parameters
● r0772[0...1] Measuring sockets output signal
● r0774[0...1] Measuring sockets output voltage
● r0786[0...1] Measuring sockets normalization per volt
5.3 Fault and alarm messages
5.3.1 General information about faults and alarms
Description
The errors and states detected by the individual components of the drive system are
indicated by messages.
The messages are categorized into faults and alarms.
Note
The individual faults and alarms are described in the SINAMICS S110 List Manual in the
section titled "Faults and Alarms". Here you can also find a chapter titled "Function
diagrams" → "Faults and alarms", which contains function diagrams for the fault buffer, alarm
buffer, fault trigger, and fault configuration.