Specifications

Control via the Operator Panel 04/04
SINAMICS G130 - Operator Panel AOP30
5-14 Operating Manual
5.3 Operation Screen Menu
Description
The operation screen displays the most important status variables for the drive unit:
In its condition on delivery, it displays the operating status of the drive, the direction
of rotation, the time, as well as four drive variables (parameters) numerically and
two in the form of a bar display for continuous monitoring.
You can call up the operation screen in one of three ways:
1. After the power supply has been switched on and the system has ramped up.
2. If you do not make any entries for two minutes, the system calls up the
operation screen automatically.
3. By pressing the MENU key twice and then F5 "OK".
READY  12:25:30 S
NSET = 1450.000rpm F_OFF= 50.0Hz
PACTV= 235.0kW Udc = 620.0V
F2F1 F3 F4 F5
N_ACT[rpm ]
1450.0 0% 50% 100%
I_ACT[Aeff]
450.0 0% 50% 100%
If a fault occurs, the system automatically displays the fault screen (see 5.8).
In LOCAL control mode, you can choose to enter the setpoint numerically (F2:
setpoint).
Settings
When you choose Commissioning / service –> AOP settings –> Define operation
screen, you can adjust the display type and the values displayed as required.
See 5.6.3