User Manual

Application Sheet CEN005
Central Floor Scope
DXR2..18-
101A
DXR2..18-
102A
4 / 4
Technical information in this document are subject to change. Drawings serve illustration purposes only.
Siemens is not responsible for content and any manual modifications.
2019-02-21
A6V10662238_en--_b_--_09
Optional
configuration
Equipment Values/range Template settings
Central operation for
shading 1 / 2
Operation switch-on delay 1 None
Active
None
Operation switch-on delay 2 None
Active
None
Operation switch-on delay 3 None
Active
None
Central service for
shading products
Service switch-on delay 1 None
Active
None
Service switch-on delay 2 None
Active
None
Service switch-on delay 3 None
Active
None
Central protection for
shading products
Protection switch-on delay 1 None
Active
None
Protection switch-on delay 2 None
Active
None
Protection switch-on delay 3 None
Active
None
Central emergency for
shading products
Emergency switch-on delay 1 None
Active
None
Emergency switch-on delay 2 None
Active
None
Emergency switch-on delay 3 None
Active
None
Engineering ∂ The ABT Site engineering tool is required to engineer DXR2 automation stations.
∂ See the Siemens Download Center www.siemens.com/bt/download for the latest application configurations and
workflow tutorials.
It is the life safety and security management, and not Desigo room automation, that is responsible for fire
detection and evaluation of the correct HVAC emergency operating modes for a fire section and primary plants.
The configurable Desigo room automation can switch all available luminaires to a specified value at the highest
priority during an emergency. This is not emergency lighting or evacuation route control, but rather is only a
supporting measure during an emergency to supply all rooms with the maximum brightness.
The configurable Desigo room automation does not support emergency lighting control with service and test
functions for decentralized or centralized batteries.
Siemens Switzerland Ltd
Building Technologies Division
International Headquarters
Gubelstrasse 22
CH-6301 Zug
Tel. [phone]
Fax [phone]
www.siemens.com/buildingtechnologies
© 2017
Siemens Switzerland Ltd
Subject to change