Commissioning Instructions

Step 2 - Setting Up Connection
A6V11672234_en--_a
9 | 22
Step 2 - Setting Up Connection
When the project opens, go to
Startup page, click on the top right.
The screen displays the following tabs:
● Room unit connection
Note: Not used for DXR1.X type devices
● USB
● Ethernet
2.1
Click the tab for how you will physically connect.
2.2
If you have not done so already, make the physical connection with a
provided cable.
The steps below are not standard balancer procedure steps and should rarely be
used. They are provided as a convenience, just in case.
● Under
Target selection select the Device type that you want to work with. (This
may or may not be the device you are physically connected to.)
● USB
-
IP device (not used for DXR1.X devices)
-
MS/TP device (not used for DXR1.X devices)
-
PTP device: Point (PC) To Point (DXR1.X) connection. This is the only way
that you want to connect the DXR1.X with USB port.
● Ethernet connection
-
IP device
-
MS/TP device
● Network interface: Select the PC network card from the dropdown.
● IP address: Select the network card IP address from the dropdown. This is only
needed if more than one IP address is setup for the selected network card.
● UDP port number configured for the network: typically 0XBAC0.
● Click
Connect.
– Note: If downloading application for multiple devices (IP and MSTP)
simultaneously, you need to perform the following steps, and then click
Connect.