User Manual

ManualsBrandsSiemens ManualsRoom controlsSash Open Area Module (SOAM), DXA.S12C, Data Sheet

A6V10801251 Building Technologies

02.23.2018

Sash Open Area Module (SOAM)

DXA.S12C

The Sash Open Area Module (SOAM) provides advanced sash management for

DXR2 and PTEC based Fume Hood Controllers.

● Sash management for advanced fume hoods with 2-10 sashes

● Supports DXR2 lab and PTEC based Fume Hood Controllers

● Supports vertical and horizontal sash combinations

● Support for retractable cable sash and UniTrack sensors

● LED’s for communications (sensor failure, calibration and SCOM communication

status)

● Local tool interface for sash sensor calibration

Summary of content (6 pages)

PAGE 1
Sash Open Area Module (SOAM) DXA.S12C The Sash Open Area Module (SOAM) provides advanced sash management for DXR2 and PTEC based Fume Hood Controllers. ● ● ● ● ● ● A6V10801251 02.23.
PAGE 2
Use These applications measure the fume hood sash positions and calculate a total face area. The face area is available for use both as a 0 to 10 V analog output or a digital signal for use with DXR2 lab controllers.
PAGE 3
53” Vertical UniTrak Sash Kit 546-00485 71” Vertical UniTrak Sash Kit 546-00484 85” Vertical UniTrak Sash Kit 546-00443 34” Horizontal Sash Kit 546-00495 43” Horizontal Sash Kit 546-00493 52” Horizontal Sash Kit 546-00492 70” Horizontal Sash Kit 546-00491 84” Horizontal Sash Kit 546-00442 Product documentation Topic Title Document ID: Installation, sash wiring Fume Hood Sash Open Area Module (SOAM) Installation Instructions A6V10801244 Installation, sash wiring Retracting Cable Sash S
PAGE 4
Outputs Analog outputs AO 0 to 10 V Interfaces Interfaces USB (2.0) Plug: Type B. Data rate: 1.5 Mbps and 12 Mbps. Galvanic isolation to ground. No isolation from I/O ground. Sensor Bus Digital communication to DXR Lab Controller Wiring connections Wiring connections Pluggable screw terminals Copper wire or copper strands with ferrules 1 x 0.6 mm (0.02 in) dia. to 2.5 mm2 (0.004 in2) or 2 x 0.6 mm (0.02 in) dia. to 1 mm2 (0.0015 in2). Copper strands without ferrules 1 x 0.6 mm (0.02 in) dia. to 2.
PAGE 5
Siemens Industry, Inc. 5 A6V10801251 07.06.
PAGE 6
Issued by Siemens Industry, Inc. Building Technologies Division 1000 Deerfield Pkwy Buffalo Grove IL 60089 Tel. +1 847-215-1000 6 Siemens Industry, Inc. Document ID A6V10801251 Edition 02.23.2018 © Siemens Industry, Inc., 2018 Technical specifications and availability subject to change without notice. A6V10801251 02.23.