User Guide

Room operation as of V6
3
Selecting Room
35
Siemens Desigo TRA User Guide
A6V10415564_en_a_21
Building Technologies 2015-06-23
3.5.7 Positioning Blinds
Control is automatic by default based on installed switches, presence detector, and
room request. You can raise and lower blinds for individual segments as needed.
 The room is selected and room graphic is displayed.
1. Select Room > Segment(s) and then the desired room segment in the Names
column.
2. Select the display in the column Blinds and click 0.00%.
 A red frame is displayed when selected and the properties are displayed in
the Contextual pane of the
Operation tab.
3. Proceed as follows:
– Change angle position:
a. Select the property Angle blinds command and click Manual.
b. In the Value drop-down list, enter a new value.
c. Click Send.
 The message Manual successful is displayed.
– Open or close blinds:
a. Select the property Height blinds command and click Manual.
b. In the Value drop-down list, enter a new value.
c. Click Send.
 The message Manual successful is displayed.
NOTE:
You can operate the blinds as follows:
1. Select the room segment.
2. Select the
Related Items
tab.
3. Select
Graphics
and then the segment link.
4. Select the blinds object and then, in the
Operation
tab, the property
Angle
blinds command
or
Height blinds command
.