User Guide

Room operation as of V6
3
Selecting Room
33
Siemens Desigo TRA User Guide
A6V10415564_en_a_21
Building Technologies 2015-06-23
3.5.5 Editing Setpoints
 The room is selected and room graphic is displayed.
1. Select Room > Preset Setpoints and then:
– Cooling
– Heating
 A red frame is displayed when selected and the most important values for
heating and cooling are displayed in the Contextual pane of the
Operation
tab.
2. Select for:
– Cooling, property Cooling setpoint Comfort
– Heating, property Heating setpoint Comfort
3. Click Manual.
4. In the Value drop-down list, enter a new setpoint.
5. Click Send.
 The message Manual successful is displayed.
3.5.5.1 Displaying the Present Calculated Setpoint
The present room setpoints are calculated using various indicators. The setpoints
used to control the room depend on the room Operating mode and the set room
adjustment.
 The room is selected and room graphic is displayed.
1. Click Next .
 Plant Operating modeand Temperature setpoint determination are
displayed.
 The table displays the setpoint calculations (from left to right).