User Guide

Room operation as of V6
3
Selecting Room
27
Siemens Desigo TRA User Guide
A6V10415564_en_a_21
Building Technologies 2015-06-23
 The Operation tab displays properties Room Operating mode and Comfort
button.
2. Select the Comfort Button property and click Manual.
3. In the Value drop-down list select:
– Active: The room is controlled for two hours to Comfort and then
automatically set to
Inactive.
NOTE: The time can be set in the Setup and Service Assistant under the
Time for Comfort Button property.
– Inactive: The Comfort state is switched off and set to Enable after time
expires.
4. Click Send.
 The message Manual successful is displayed.
3.5.3 Applying Scene
Use this functions if you need a scene for the room Operating mode.
 The room is selected and room graphic is displayed.
1. In the room graphic, select room operator unit.
 A red frame is displayed if selected .
 The Operation tab displays the Value and In progress properties.
2. Select the Value property.
3. In the Value drop-down list:
– Scene_x (the room is controlled by the selected scene)
– No Action (the state switches to automatic mode)
4. Click Change.
 The message Change successful is displayed.
 The room Operating mode changes to the corresponding scene.