User Guide

2
Room operation up to V5.1
Positioning Blinds
18
Siemens Desigo TRA User Guide A6V10415564_en_a_21
Building Technologies 2015-06-23
2.7 Positioning Blinds
 The room is selected and room graphic is displayed.
1. Select the Blinds object and Value object .
 A red frame is displayed when selected and the most important values for
this blinds object are listed in the Contextual pane of
Operation tab.
2. Select the Operation tab.
 The blinds properties display.
Position Height
1. Select the Height property and click Manual.
2. In the Value field, define the desired value or use the sliding controller.
3. Click Send.
 The message Manual successful is displayed.
 The blinds object is dynamically displayed.
 Change Present priority and Priority Matrix to 13.
Position Angle
1. Select the Angle property and click Command.
2. In the Value field, define the desired value or use the sliding controller.
3. Click Send.
 The message Manual successful is displayed.
 The blinds object is dynamically displayed.
 Change Present priority and Priority Matrix to 13.
NOTE:
Successful operation only possible if you can write at a higher priority [➙ 88] than
is displayed on the status bar for the
Priority Matrix
. You can, for example,
overwrite present priority 13 with priority 8.