User Guide

Room operation up to V5.1
2
Editing Setpoints
15
Siemens Desigo TRA User Guide
A6V10415564_en_a_21
Building Technologies 2015-06-23
 Displays the room Operating mode properties.
3. Select the Value property and click Manual.
4. In the Value drop-down list box, select the Operating mode.
5. Click Send.
 The message Manual successful is displayed.
 In the Extended Operation tab the Present Priority and Priority Matrix changes
to 8 or 13.
NOTE:
Successful operation only possible if you can write at a higher
priority [➙ 77] than
is displayed on the status bar for the
Priority Matrix
. You can, for example,
overwrite at the present priority 13 at 8, but not 7.
The display arrow indicates an active priority of 1 to 8. At priority 8, you can
change the Operating mode, for example,
Protection
to
Pre-Comfort
.
2.3 Editing Setpoints
 The room is selected and room graphic is displayed.
 You can write a command at the Priority Matrix (see NOTE).
1. Select Settings > Setpoint Heating Comfort or Setpoint Cooling Comfort.
 A red frame is displayed when selected and the most important values for
the setpoint are listed in the contextual pane of the
Operation tab.
2. Select the Operation tab.
 The room setpoint properties are displayed.
3. Select the Value property and click Manual.