Environmental Declaration

EPD - Type II
Based on ISO 14021
Building Parts
Al alloy Housings 348g
Steel Axles, Plate, Spring 91g
Zn / Zn alloy Hub 135g
Free cutting Steel Pinions 8g
Steel stainless Screws, Spring, Pin 9g
Cold work band steel Gear Wheel 35g
Case hardening steel Gear 48g
Tempering steel Bracket 34g
Steel; zinc plated Plate 51g
steel CrNi ## 1g
CuZn; nickel plated Push in fitting pneumatic 20g
Steel, copper, PCBA Motor 155g
PVC / copper PVC cable power 104g
Polyester Label on actuator 2g
Lubricant Grease 2g
FR4; TBBA; solder SnAgCu PCB Assembled 57g
*Variant parts list
[g]
Total weight of device
VAV damper
Fire load [MJ]
Packaging
Cardboard [g]
Comments
HLBHA00250QF
3’236
1’911
HLBHA00200QF
2’673
1’348
1’650
56
1’550
75
HLBAA00315QF
5’886
4’561
2’060
165
EU-directive 2011/65/EU (RoHS)
The device does not contain substances in concentrations and applications banned under the EU RoHS Directive, including the 4 phthalates added to Annex
II in 2015.
The device contains the following substances of the candidate list according to Article 59 (1, 10) of the regulation (EC) No. 1907/2006 concerning the
Registration, Evaluation, Authorisation and Restriction of Chemicals (REACH) in concentrations above 0.1 % w/w. Contained REACH candidate substances,
including those which will become known at a later date, are listed on the delivery note.
Lead, CAS-Nr.7439-92-1; Silicic acid (H2Si2O5), barium salt (1:1), lead-doped, CAS-Nr.68784-75-8; Lead monoxide (lead oxide), CAS-Nr.1317-36-8
(Status according to the creation date of this document.)
Legal Disclaimer: This declaration is for information purpose only.
Siemens Schweiz AG therefore does not assume liability for any error or for any consequences which may arise from the use of this information to the maximum extent under the
law.
This Environmental Product Declaration does not constitute a guarantee of the composition of a product, neither does it guarantee that the product will retain a particular
composition for a particular period.
Regulation (EC) No. 1907/2006 (REACH)
The device is low-halogen with exception of:
PCB (TBBA); PVC cable; Grease; Motor
Others
The device is classified as waste electronic equipment in terms of the European Directive 2012/19/EU (WEEE) and must
not be disposed of as unsorted municipal waste. Regarding disposal, use the systems setup for collecting electronic waste.
Observe all local and applicable laws.
Disposal
PCBAs (Printed Circuit Board
assembled)
Metals
Restricted Page 2/3