Basic Documentation

57 / 68
Siemens RDU341 Basic Documentation CE1P3172en
Building Technologies 2017-02-17
5. Supported KNX tools
5.1 ETS
ETS is an engineering tool. It is used to set up the communication of the RDU KNX
thermostat and assigns the communication object to group addresses (S-mode).
Parameters are only used for choosing (making visible / hiding) the communication
objects.
This Manual does not describe how to operate ETS and commission a device.
Refer to the KNX Manual for more details.
Setting RDU KNX parameters is only supported by ETS3f or higher.
5.1.1 Parameter settings in ETS
For setting the parameters, open the project and select a device.
To start the parameter settings, select Edit, then Edit parameters.
∂ Parameters are only used to choose the communication objects
∂ The tool required is ETS version 3f or higher!
5.2 ACS tool
With the ACS tools, the RDU KNX thermostats can be commissioned (physical
address, application, parameters). They can be operated or monitored via bus
during normal operation.
This Manual does not describe how the physical address is defined. Also, it only
gives a brief overview of the main functionality of ACS.
For more information, refer to the ACS online help.
Setting RDU KNX parameters is only supported by ACS Version 5.11 or
higher.
ETS
STOP
Note!
Notes:
ACS
STOP
Note!