Commissioning Instructions

ABT-SSA (Setup & Service Assistant)
User interface overview: Installation
2
32 | 76
Siemens
A6V10429119_en--_a_07
Building Technologies
2018-12-19
KNX PL-Link Unconfigured
The KNX PL-Link bus > Unconfigured view displays the automation stations with KNX PL-Link that were
detected on the KNX PL-Link bus, but not yet configured. This list must be empty to successfully complete KNX
PL-Link identification.
Display unconfigured KNX PL-Link devices
1. Select PL-Link in the upper navigation pane.
2. Selected Unconfigured in the left navigation pane.
 The PL-Link Unconfigured Web page displays.
KNX PL-Link Programming Mode
The KNX PL-Link Programming Mode Web page is reserved to do certification activities. Enable sets KNX
devices in a programming mode (active).
Do not use Enable.