Commissioning Instructions

ABT-SSA (Setup & Service Assistant)
User interface overview: Installation
2
25 | 76
Siemens
A6V10429119_en--_a_07
Building Technologies
2018-12-19
Assigning DALI devices
The DALI bus > Identification view displays the current DALI bus configuration and allows you to assign DALI
devices to an engineered DALI data point.
To perform the procedures in this section, select DALI bus in the command bar and Identification in the left
navigation pane.
Assign DALI devices
 The DALI bus status is Operational.
1. In the Online list table, click to identify the DALI device with the DALI bus short address.
 The DALI device flashes (e.g., lamp on site). The lamp flashes as long as you click again. Then, the
lamp continues flashing only for a short time.
2. (Optional) Select Reset device parameters during assignment if you first want to delete the configuration
parameters in the DALI control gear.
3. Drag and drop the DALI device to the table row containing the engineered DALI data point.
 The factory setting is executed (option).
 The DALI device sends its serial number. The serial number is entered in the list.
 The DALI device is configured using the device configuration data stored on the automation station. The
status display changes to Operational.
Note: The DALI bus short address and the serial number is transferred to ABT Pro following read back of data.
They can be listed in ABT Pro via the DALI report.
Unassign DALI devices
1. Table of configured DALI devices (table on the right side):
Click to identify that DALI device.
2. Click to unassign the DALI device.
 The short address, serial number and designation (Device online) is removed from the engineered data
point. The status display goes to Unassigned device.
 The DALI device is now listed in the Online list.
The DALI device keeps the DALI bus short address.