User Guide

Reports
Reports Reference
8
332 | 393
Siemens
User Guide Version 3.0
A6V10415471
Building Technologies
2017-11-30
8.2.16 Reports Troubleshooting
The following table may help you to resolve possible errors when working with
reports for operating procedures.
Working with Reports for Operating Procedures
Problem
Cause
Resolution
Notes
Reporting snap-in
does not display.
● You do not have
the Show
privilege for
Reporting.
● Contact the system
administrator to obtain
the Show privilege.
Report for operating
procedures is not
executed.
● Configured
Report Definition
is out of Scope.
● Configured
Report Definition
is either deleted
or corrupted.
● Report Definition
is not configured
in operating
procedures.
● Contact the system
administrator.
● Configure a new report
definition.
● Ensure that the report
definition is configured
in the Operating
Procedure step.
● See Configuring a
New Operating
Procedure for the
configuration steps.
Save User Input and
Send to Output
buttons are not
available.
● You do not have
the Show
privilege for
Reporting.
● Configured
Report Definition
is out of Scope.
● Configured
Report Definition
is either deleted
or corrupted.
● Report Definition
is not configured
in operating
procedures.
● Configured
report does not
contain form
controls. In this
case, only the
Save User Input
button is not
available.
● Contact the system
administrator and get
the Show privilege.
● Contact the system
administrator.
● Configure a new report
definition.
● Ensure that the report
definition is configured
in the Operating
Procedure step.
● Configure the report
with form controls.
● See Configuring a
New Operating
Procedure for the
configuration steps.
Report for operating
procedure does not
display the
configured table in
the Run mode.
● The configured
table’s content
provider is not
available in the
project.
● One of the
element such as
graphics has not
received data
from the
service/graphics
engine.
● Contact the system
administrator and get
the content provider
added to the project.
● Create a graphics
containing the object in
event.
To create a graphics,
see Creating a Graphic.