Operating Instructions

3
Events
Handling Events
24
Siemens Desigo™ CC Getting Started A6V10415475_en_a_21
Building Technologies 2015-06-30
the top, and the operating procedure in the left pane. The operating
procedure contains all the steps that must (or optionally can) be executed,
presented in sequential order. The first step is already selected, and the
Primary pane displays the appropriate tool for carrying it out.
2. Click Acknowledge .
 The event is acknowledged.
3. If the respective commands are available, do one or both of the following;
otherwise, proceed with the assisted treatment:
– Click Silence to silence the field panel.
– Click Start Remote Notifications to manually send a remote
notification message.
4. Go through each step of the procedure, proceed as follows:
a. Depending on how the system is configured, certain steps may be
automatically executed when you initiate the Assisted Treatment (for example,
automatically sending a remote notification message), or you instead have to
select the step and perform certain actions (such as, filling out an event-
treatment form) before you can check off that step.
b. Once you have executed a step, depending on the system configuration, one
of the following may happen:
- If a gray check box displays next to the step, this means that you must
first complete any required tasks (for example, printing the graphic of an area
or filling out and saving an event-treatment report) before you check off that
step.
- If a white check box displays next to the step, this means that you can
select it to check off the step. You can then continue Assisted Treatment by
selecting the next step in the procedure, and again, performing the action
required by the associated treatment tool. Complete all the remaining steps in
the same way.
 Once you have carried out the entire procedure, you can reset the event.
5. Click Reset .
 The event is reset and you can close the event.
6. Click Close .
7. In the Assisted Treatment window, click the event button.
 The Assisted Treatment window closes and the event is cleared from the Event
List.