User Manual

Operating Reference
Reports
3
246 | 352 A6V10415471_en_a_40
● When you add a Condition filter to the All Logs table, you cannot apply the OR
operator between two filter expressions set on two different columns.
● You can apply the OR operator between two filter expressions set on the same
column. To apply the OR operator on the same column, select the column and
the operator, press SHIFT or CTRL, depending on whether you want to select
values listed next to each other or away from each other, and then click Add.
● You cannot apply the NOT operator in the Condition filter for a Log View table.
● You can only apply the Equal to (=) operator to the following columns in the
Condition Filter dialog box.
– Discipline
– Subdiscipline
– Type
– Subtype
– Source Description
– Source Name
– Source Designation
– Source Location
– Source Designation [Application View]
– Source Designation [Current View]
– Source Designation [Management View]
– Source Location [Application View]
– Source Location [Current View]
– Source Location [Management View]
– Source Identifier [Internal]
Reports for Operating Procedures
Reports configured in operating procedure steps allow you to view and enter Event
Treatment related information when executed for a selected event from Assisted
Treatment. In addition to the existing reporting elements, you can add form controls
to these reports. You create and configure a report for operating procedure steps in
the same way as you would create and configure any report. When executed in the
context of the selected event, the report displays the event treatment related
information and allows you to enter information in the form controls.
NOTE:
You cannot use trend plots and trend tables in reports for operating procedures
as these elements do not display any data when the report is executed from
Assisted Treatment.
You can enter information in the following scenarios:
● The event is treated for the first time; the operating procedure step is
configured as repeatable and is in progress.
● You re-select the same event, for a repeatable step that is not yet complete.
If you re-select the same event with a non-repeatable step that is complete, you
cannot perform activities such as editing information, sorting entries in tables, or
resizing columns. You can only view and route the information to a file, email, or
printer as configured in the report definition.
Information entered in the form controls can be viewed by users on different client
computers for the same step in the same event. However it can be edited only if
the step is configured to be repeatable.
You may need to contact the system administrator, if you face either of these
issues when working with reports for operating procedures:
● The report is not executed.
● The report does not display the configured table in the Run mode.
● The report is not getting routed to the specified folder.