User Manual

Operating Reference
Scheduling
3
A6V10415471_en_a_40 231 | 352
station schedules can process both BACnet and non-BACnet object types (BACnet
schedules process only BACnet object types).
You can also create exceptions to schedules. When a management station
exception is ON, it overrides the weekly schedule. When the exception is OFF,
control returns to the weekly schedule.
Values are displayed as per value scaled units (if configured). For more
information, see Value Scale Units.
This section provides the general reference information on management station
schedules. To get started with procedures, navigate to the step by step section for
management station schedules.
Weekly Management Station Schedule
In the case of a weekly schedule, specify the Active or Inactive values only once.
These values are applicable for the entire week and for the complete duration of
the schedule. You create a weekly schedule from the Sub-Type drop down list in
the Setup tab. In this case, the schedule will not trigger an Inactive value at mid
night as an Active entry is added at 12.00 a.m from the Schedule Entries tab. The
last state of the day will be retained post mid night until the next day schedule entry
is triggered.
Example 1: Active Value: 50, Inactive Value: 60:
Time period for the schedule (Active : 12:00 a.m., Inactive : 9:00 a.m., Active : 6:00
p.m.)