Installation Instructions

18
A6V11349526_enUS_b Siemens Industry, Inc.
Building Technologies Division
XNET Card Tab Settings
1. Select Programming mode. Click OK to acknowledge the warning about XNET drivers
stopping.
2. Set a card identifier and click Set ID.
3. Select a network wiring type.
4. If NRCs are used in the XNET, the NRC checkbox should be checked.
5. Click Save.
NOTE: If multiple cards are installed, the test button can be used to identify the XNET card.
When the test button is pressed, the LEDs on the XNET card will flash.
XNET Driver Configuration Page
Configuration Tips
 When you enter and save the driver configuration parameters (at least the Network Settings are
required), two pre-defined nodes are automatically inserted under the driver to act as reference
objects for handling special events, namely:
–Internal events related to the driver (XNET [system name] Node)
–Events that cannot be associated to any object due to a missing or inconsistent configuration
(XNET Unidentified Node)
 You can customize the default description of a node by selecting it in System Browser and
modifying the Description text in the Object Configurator tab.
Notes:
1. The NCC2F Card Driver is installed for serial port information to be displayed.
2. The serial port may be related to an emulated port supporting a connection to the XNET via a
read-only solution (for read-only solution, refer to the Help Utility for additional information).
–Network type: Select XNET in the drop-down list.