User Guide
9
Reports
Examples
300
Siemens User Guide Version 2.1 A6V10415471_en_a_21
Building Technologies 2015-07-15
configured table in
the Run mode
project.
One of the
element such
as graphics
has not
received data
from the
service/graphic
s engine.
Create a graphics
containing the object
in event.
PDF document
generated for
operating
procedure does
not display any
data
Data is not
available as
per the filters
applied to the
configured
table.
Graphics is not
available for
the object in
event.
Check and correct
the applied filters.
Create a graphics
containing the object
in event.
To create a graphics,
see Creating a
Graphic [➙ 66] in the
Graphics help.
The report for the
operating
procedure cannot
get routed to the
specified printer
Printer is
faulty.
Printer does
not have
paper.
Printer is
jammed.
Printer is not
reachable
Printer is
offline
Printer door is
open
Rectify the printer
related issues
The report for the
operating
procedure cannot
get routed to the
specified folder
You do not
have
permissions
for the
specified folder
Either contact the
system administrator
to receive the
required permissions
on the configured
folder or configure a
new folder.
Table in the report
does not display
any data
The Report
Definition has
an invalid
condition filter
Ensure that the
condition filter is
applied properly.
For steps to apply
the condition filter
to a table, see
Applying a
Condition Filter
[➙ 273].
9.22 Examples
This section provides examples on creating and configuring reports. Procedures on
how to create and configure the reports, along with information on their constraints
are also covered.
The examples cover certain aspects that you must know before creating or
configuring a report such as the syntax to be followed when applying a condition
filter, significance of column names with and without square brackets [] and so on.
By referring to these examples, you will be able to create and configure any type of
report.
Objects Report [➙ 301]
Activities Report [➙ 304]
Event Details Report [➙ 307]