User Guide

6
Remote Notifications
Working with Remote Notifications
140
Siemens User Guide Version 2.1 A6V10415471_en_a_21
Building Technologies 2015-07-15
 If the operation completes successfully, the remote notification status
becomes Aborted and you cannot restart it; the status of pending
recipients becomes Cancelled.
– To stop the escalation for a group of a remote notification before it starts,
under
Recipients, select the group for which you want to stop the
escalation, then click
Stop RENO procedure escalation .
You can only stop one escalation at a time. If there is more than one
recipient group with an escalation list, to stop all escalations you must
select each group in turn and repeat this step to disable its escalation.
 The escalation for the selected group is now disabled. If the group does not
reach its threshold of required responses, the escalation (if any) does not
start. The status of the groups and recipients involved becomes Stop.
– To view the content of a message sent to a recipient, expand the remote
notification, and under
Recipients, select the appropriate recipient.
 The message displays in the Message area.
6.3.5 Handling a Manual Alarm-based Remote Notification
Depending on configuration, the system may allow you to manually send a remote
notification message to preconfigured recipients when specified alarm conditions
arise. You can monitor the progress of this type of remote notification and
optionally control it as follows.
 One of the following scenarios occurs:
-You are handling an event and RENO Messages displays in the Primary pane.
- You have selected a remote notification configured in the system and
available when navigating the Application View (Applications > Remote
Notifications).
 The message status tells you that the remote notification type is manual. For
example,
Alarm ID 40 Manual .
1. In the Message Status area, select a remote notification.
2. To send the remote notification, click Start RENO procedure .
This operation is the same as starting [➙ 114] a remote notification using the
command in the event descriptor during event treatment. During the send
operation, the icon is dimmed.
3. While monitoring the progress of a remote notification, depending on the
available commands in the RENO Messages toolbar, you can optionally do one
or more of the following:
– To send the remote notification again, click Start RENO procedure .
– To stop monitoring the message status, click Stop RENO procedure .
This operation is the same as stopping [➙ 114] a remote notification using
the command in the event descriptor during event treatment.
 If the operation completes successfully, the remote notification status
becomes Aborted and you cannot restart it; the status of pending
recipients becomes Cancelled.
– To stop the escalation for a group of a remote notification before it starts,
under
Recipients, select the group for which you want to stop the