User Guide

5
125
Siemens User Guide Version 2.1
A6V10415471_en_a_21
Building Technologies 2015-07-15
recurrence may be available, or one assisted procedure for the entire set of
recurrences may be available.
5.5.13.1 Handling Recurring Events from Event List
In Event List, the Counter column for an event contains a number. This means
that it is a recurring event [ 124] that includes some recurrences.
1. In Event List [ 84], click the counter for the event.
NOTE: During the selection, you may either individually select a single parent
event (with all its child recurrences) or multiple parent events. For multiple
selections, you must select either only
parent
events or only
child
recurrences
of the same parent event (for example, you cannot select a parent event and
any child recurrence belonging to another parent event).
All the recurrences appear as smaller event buttons under the selected
parent event button(s) (each acting as a
container
of recurrences) followed
by the event descriptors. The first recurrence is the one having the highest
priority. The Commands column of the parent event
contains all the
available alarm-handling commands.
2. According to command availability, do the following:
Acknowledge [ 112] the event(s).
If available by configuration:
- Silence/unsilence [ 113] a field panel.
- Start/stop [ 114] remote notifications.
Reset [ 112] the event(s).
Close [ 113] the event(s) or suspend [ 113] it.
When acknowledging recurring events...
If you acknowledged the first recurrence (which always corresponds with the
parent event), its event button stops flashing, as well as the parent event
button.
If you acknowledged a recurrence which is not the first in the set, only the
corresponding button stops flashing.
If you acknowledged the parent event, all the event buttons of the child
recurrences stop flashing.
When handling an individual recurrence...
The selected command is sent only to it.
When the first recurrence is fully handled…
It disappears from the set and the event details for the parent event refresh to
display data related to the next (by date and time) child recurrence.
NOTE:
You cannot collapse (or hide) Event List while recurrences display. Click the
counter again to hide the recurrences. Then, collapse (or hide) Event List.