User`s manual

Command Descriptions, Continued
“test” Command
This command places a selected port into a hardware diagnostic mode.
The command
test 4
places port 4 into test mode. The hub will generate poll messages on
port 4. All other ports continue to operate normally. The command
test off
turns off test mode. Only one port at a time may be in test mode.
“timeout” Command
This command may be used to disable the user login timeout. Normally,
if a user has not issued a CLI command for five minutes, the hub-half will
automatically shut down the user’s login session. This command may be
used to defeat (and re-enable) this timeout:
timeout off
Disables timeout. The hub-half will not
automatically log out the user, regardless of the
time elapsed since the user last issued a CLI
command.
timeout on
Re-enables the five-minute CLI timer.
2000585-001 Command Summary • 81