User`s manual

Command Description, Continued
“help” Command
This command generates a simple list of available commands.
“list” Command
Enter the list command at any time from the Configuration Management
interface to see event buffer messages. The list command has an
internal current sequence number that is set to 1 each time a
Configuration Management login occurs. The list command will show 21
messages each time it is entered, beginning with the current sequence
number. The current sequence number is updated each time list is used.
A new current sequence number can be entered with the list command:
local> list 10
10 LOG:Port 10: Start probing 09/27
08:14:22.42
11 LOG:User logged in 09/27
08:14:27.00
12 LOG:Port 10: Start link validation 09/27
08:14:29.92
13 LOG:Port 1: Start link validation 09/27
08:14:29.93
14 LOG:Port 10: Link up (this half) 09/27
08:14:33.92
15 LOG:Port 1: Link up (both halves) 09/27
08:14:33.93
16 LOG:Port 4: Start link validation 09/27
08:20:22.52
17 LOG:Port 6: Start link validation 09/27
08:20:22.56
18 LOG:Port 4: Link up (both halves) 09/27
08:20:26.52
19 LOG:Port 6: Link up (this half) 09/27
08:20:26.56
20 LOG:Port 5: Take port off-line 09/27
08:20:54.84
21 LOG:Port 7: Take port off-line 09/27
08:21:10.27
22 LOG:Port 7: Start test mode 09/27
08:21:13.07
23 LOG:Port 1: Link down (no carrier in three polls) 09/27
08:23:23.77
24 LOG:Port 1: Lost carrier 09/27
08:23:23.77
25 LOG:Port 1: Start probing 09/27
08:23:23.77
26 LOG:Port 1: Start link validation 09/27
08:23:46.32
27 LOG:Port 1: Link up (both halves) 09/27
08:23:50.32
28 LOG:Port 7: Stopped test mode 09/27
08:27:43.41
29 LOG:Port 7: Take port off-line 09/27
08:27:43.41
30 LOG:User logged out 09/27
08:34:45.48
31 LOG:User logged in 09/27
08:41:05.05
78 • Command Summary