User`s manual

Firmware Updates, Continued
6. Click on Send Text File.
The Send Text File dialog box will appear. In the Look in: window
choose the directory on your PC where the DNH files reside.
7. Under Files of type select All files (*.*).
8. Under File name type in the upgrade version file name (DataNET
hub.hex).
This will start the down loading of the files. Once the download has
begun the block numbers will be displayed as they are transmitted.
The upload will take approximately 45 minutes to complete.
9. Repeat steps 1 through 8 for Hub ‘B’ half.
MAC Address
Configuration
To configure the Ethernet MAC address after the firmware update,
perform the following steps:
1. At the Local > prompt type: config address ethernet
xx.xx.xx.xx.xx.xx
Where: xx.xx.xx.xx.xx.xx is the MAX address for the DataNET Hub
board. Typically the address would be in the range 00.c0.c9.01.21.00
through 00.c0.c9.01.21.ff.
2. Press ↵ Enter to complete your entry.
2000585-001 Data Communications Setup • 61