User`s manual

Setting Network Address
Description
This section provides instructions to configure an Advance DataNET ‘A’
or ‘B’ Hub with its own Network Address.
Before You Begin
1. Connect a standard 9-pin COM cable from the designated PC COM
(see page
49, step 7.) to Hub ‘A’ or ‘B’ Configuration Port located on
the Communications Board.
2. Open Windows HyperTerminal program on your PC; reference
Configuring Your PC, page
49.
3. Connect and Log on to DNH; reference Establishing a Connection,
page
54.
Command Line
Definitions
Chapter 4, Command Line Summary, provides definitions for all of the
commands you will be using in this chapter.
Instructions
1. Log on locally to the DNH.
The Connect Screen will appear with the login information and the
local prompt. The local prompt indicates that you are communicating
with the DNH connected directly to the PC.
2000585-001 Data Communications Setup • 57