User`s manual

Establishing a Connection, Continued
Password Format
A password name can consist of any combination of alphanumeric
characters. The alphanumeric name must have a minimum of five and a
maximum of twenty characters. The DNH Communication board is
shipped from the factory with the word “password” entered as the
default password name.
The user can change the password name at any time. To do this login
using the current password then type: “password stand stand”. Where
the word stand is your new password entered twice to verify that it was
properly entered.
How to Change
Password
How to Log Out
You may log out or close the Configuration and Diagnostic program at
any time by typing logout. However, the Configuration and Diagnostic
program will automatically log you out after five minutes.
How to Log On
The following procedure assumes that the HyperTerminal program,
residing on your PC, has been configured to communicate with the DNH,
and the PC is connected to the DNH ‘A’ or ‘B’ Configuration Port.
1. Open Windows HyperTerminal program.
2. Press ↵ Enter twice
The following dialog box appears:
2000585-001 Data Communications Setup • 55