Advance DataNET Hub User's Manual

80 •
••
• Command Summary 2000585-001
Command Descriptions, Continued
This command logs the user out of a session. The user must be logged
out of the local device to login to a remote device.
This command may be used to display statistics for the DataNET sec-
tion. If a link number is given, statistics are displayed for just that link. If
no link number is given, summary statistics for all DataNET links are
given. If the keyword “clear” is given, the statistics counters are reset to
zero
:
netstat dn [link] [clear]
Example:local> netstat dn clear
SCC 2: Subordinate Link 9. RUNNING
SCC 3: Principal (mux)Links 1 through 8. RUNNING
SCC 4: Cross-link Link 10. RUNNING
DataNET Statistics for all DN Links
Frames Sent 4967
Frames Sent/Retried 60
Frames Sent/Redirected 60
Frames Sent w/Errors 0
Frames Sent UnACKnowledged 0
Frames Received 4372
Frames Receiver Not Ready 0
Frames Received w/Errors 0
Link down 54
local>
This command will enable or disable normal DataNET communication on
individual ports. Before placing a port into “test” mode (see test com-
mand below), the port must first be taken offline with:
port stop num
where num is a port number, 1 through 9.
This command may also be used to reset a port that has been automati-
cally taken out of service by the hub after detection of a DataNET topol-
ogy loop:
port start num
This will re-start normal DataNET communications on a port.
“logout” Command
“netstat” Command
“port” Command