Commissioning Instructions

4G Dongle Setup
Connecting dongle
1
6 | 7
A6V12059208_en--_c
1.3 Connecting dongle
The USB dongle can be plugged into any USB port. It is recommended to use
port X60. A connected WAN cable can be plugged in simultaneously. The dongle
is set with higher priority and communication channel will be changed
automatically once a connection is established. When the dongle is removed,
WAN port will be activated again automatically.
1. Connect a LAN cable to X1P1 port on the Connect X300.
2. Connect the dongle to USB port X60 on the Connect X300.
 The WWAN0 interface will be created if an internet connection exists. If 4G
connection fails and WAN port X2P1 is connected to a wired network, the
system will try to connect via WAN0.
3. To ensure that a proper connection is given, check the following indicators:
– Connection LED on the Connect X300 device is flashing orange.
– WWAN0 port is displayed on local device UI under Network > Route.
– The cloud connectivity state Connected is displayed.