Operating instructions

Commissioning

5.1 Single Commissioning

Control Units CU240S

Operating Instructions, 10/2007, A5E00766042B AC

5.1 Single Commissioning

Overview

For single commissioning, you set the parameter of the inverter manually. You use BOP

(Basic Operator Panel) or STARTER (Commissioning software via PC) for commissioning.

Note

We recommend commissioning via STARTER. The commissioning process using STARTER

is driven by dialog boxes and will not be interpreted in this manual. This manual describes

the parameter related commissioning via BOP.

Settings of commissioning

Commissioning the G120 inverter comprises different settings and kinds of single

commissioning. The following list provides you an overview:

● Basic commissioning

– Quick commissioning

– Motor data identification

– Speed control optimization

● Further settings for commissioning

– Calculating the motor/control data

– Commissioning the application

– Reset parameters to factory settings

– Commissioning the fail-safe functions (only in fail-safe applications)

For detailed information to the settings of single commissioning, refer to the section

"Commissioning with BOP".

Factory settings

The inverter is delivered with identical factory settings for all CU240S Control Units; except

the following settings:

● Command source

● Setpoint source

● Values depending on the Power Module

The factory settings of the Power Modules are specific for the type of PM.

For details to the factory settings, refer to the Parameter Manual.

Note

After the first power on, the fault F0395 will appear. This means, no commission is until now

implemented. After confirming the message, you can proceed commissioning.