Installation manual

5 Download

SINAMICS G120 (CU240S DP) Control via PROFIBUS

V1.0, Beitrags-ID: 45288241

5.3 Exiting the STARTER parameterizing software

• If you don't wish to set any additional parameters, then you can now exit the

STARTER commissioning tool.

• In the tree select SINAMICS G120 and transfer all of the parameter changes

into the ROM memory of the SINAMICS G120 by pressing the

button

• Then transfer all of the parameters into your offline a project by pressing the

button.

• Disconnect the PG / PC from SINAMICS G120 by pressing the

• Now you can close STARTER using Project > Close or by pressing the

button.