Installation manual

4 Configuration and wiring

SINAMICS G120 (CU240S DP) Control via PROFIBUS

V1.0, Beitrags-ID: 45288241

4.5.2 SINAMICS G120

The SINAMICS G120 is controlled and the feedback signals read-in via the I/O

addresses listed below.

Address Function

S7 program -> SINAMICS G120

PQW256 Control word 1

PQW258 Frequency setpoint

PQW260 Torque setpoint

PQW262 Control word 2

PQW264 -- Reserve --

PQW266 -- Reserve --

SINAMICS G120 -> S7 program

PIW256 Status word 1

PIW258 Frequency actual value

PIW260 Current actual value

PIW262 Status word 2

PIW264 Last fault number

PIW266 Last alarm number

For more detailed information about the configuration of the individual signals,

please refer to SINAMICS G120 Operating Instructions Control Unit CU240S,

Chapter Commissioning.

Download from:

http://support.automation.siemens.com/WW/view/en/22339653/133300