User Manual

ManualsBrandsSiemens ManualsVariable Speed DriveSINAMICS G120 CU240B/E-2 Control Units List Manual

100

List of parameters

Parameters

1-97

SINAMICS G120 CU240B/E-2 Control Units List Manual (LH11), 01/2013

Description: Displays the status of analog inputs.

Note: AI: Analog Input

Description: Displays the actual input voltage in V when set as voltage input.

Displays the actual input current in mA when set as current input and with the load resistor switched in.

Index: [0] = AI0 (T. 3/4)

[1] = AI1 (T. 10/11)

Dependency: The type of analog input AIx (voltage or current input) is set using p0756.

Refer to: p0756

Note: AI: Analog Input

T: Terminal

Description: Sets the smoothing time constant of the 1st-order low pass filter for the analog inputs.

Index: [0] = AI0 (T. 3/4)

[1] = AI1 (T. 10/11)

Note: AI: Analog Input

T: Terminal

Description: Displays the currently referred input value of the analog inputs.

When interconnected, the signals are referred to the reference quantities p200x and p205x.

Index: [0] = AI0 (T. 3/4)

[1] = AI1 (T. 10/11)

r0751.0...9 BO: CU analog inputs status word / CU AI status word

Access level: 3 Calculated: - Data type: Unsigned16

Can be changed: - Scaling: - Dyn. index: -

Units group: - Unit selection: - Func. diagram: 9566, 9568

Min Max Factory setting

- - -

Bit field: Bit Signal name 1 signal 0 signal FP

00 Analog input AI0 wire breakage Yes No -

01 Analog input AI1 wire breakage Yes No -

08 Analog input AI0 no wire breakage Yes No -

09 Analog input AI1 no wire breakage Yes No -

r0752[0...1] CO: CU analog inputs input voltage/current actual / CU AI U/I_inp act

Access level: 2 Calculated: - Data type: FloatingPoint32

Can be changed: - Scaling: - Dyn. index: -

Units group: - Unit selection: - Func. diagram: 9566, 9568, 9576

Min Max Factory setting

- - -

p0753[0...1] CU analog inputs smoothing time constant / CU AI T_smooth

Access level: 3 Calculated: - Data type: FloatingPoint32

Can be changed: U, T Scaling: - Dyn. index: -

Units group: - Unit selection: - Func. diagram: 9566, 9568, 9576

Min Max Factory setting

0.0 [ms] 1000.0 [ms] 0.0 [ms]

r0755[0...1] CO: CU analog inputs actual value in percent / CU AI value in %

Access level: 2 Calculated: - Data type: FloatingPoint32

Can be changed: - Scaling: PERCENT Dyn. index: -

Units group: - Unit selection: - Func. diagram: 9566, 9568, 9576

Min Max Factory setting

- [%] - [%] - [%]