User Manual

Index
C-817
© Siemens AG 2009 - 2013 All Rights Reserved
SINAMICS G120 CU240B/E-2 Control Units List Manual (LH11), 01/2013
OFF2, 3-695
OFF3, 3-696
P
Parameter
Access level, 1-11
Bit array, 1-18
Calculated, 1-12
Changeable, 1-14
Command data sets, 1-492
Data type, 1-12
Dependency, 1-18
Description, 1-17
Drive data sets, 1-495
Dynamic index, 1-15
Encoder data sets, 1-502
Function diagram, 1-16
Index, 1-9, 1-17
Linked parameter, 1-9
List for quick commissioning, 1-517
List of all parameters, 1-22
List of the binector inputs, 1-503
List of the binector outputs, 1-508
List of the connector inputs, 1-506
List of the connector outputs, 1-510
Long name, 1-10
Motor data sets, 1-500
Number, 1-9
Number range, 1-19
Parameter values, 1-17
Power unit data sets, 1-502
Recommendation, 1-17
Safety notices, 1-18
Scaling, 1-14
Short name, 1-10
Unit group, 1-15
Unit selection, 1-15
Values, 1-17
Password for access level 4, 1-11
PDS (Power unit Data Set), 1-15
Process data, 2-545, 2-548
PROFIBUS, 2-545, 2-548
PROFIdrive, 2-545, 2-548
PROFINET, 2-545, 2-548
pxxxx, 1-9
Q
Quick commissioning (parameters), 1-517
R
Ramp-function generator, 2-606, 2-609
Reaction to faults, 3-695
Resetting faults, 3-699
rxxxx, 1-9
S
Safety Integrated
Basic functions, 2-591, 2-597
Extended functions, 2-591, 2-597
Safety Integrated PROFIsafe, 2-606
Safety notices (parameter), 1-18
Scaling, 1-14
Setpoint channel, 2-606, 2-609
Signals, 2-671
Skip frequency bands, 2-606, 2-609
Speed control
Vector, 2-620
Speed messages, 2-671
Standard telegrams, 2-551
Status words, 2-545, 2-548
Internal, 2-570
STOP1, 3-696
STOP2, 3-696
T
Technology controller, 2-666
Technology functions, 2-664
Telegrams, 2-545, 2-548
Temperature evaluation, 2-534
Thermal monitoring, 2-671
Torque signals, 2-671
Triggering when messages are
issued (r2129), 2-682
U
Unit (parameter), 1-15
V
Values (parameter), 1-17
Vector control
Current setpoint filter, 2-634
Droop, 2-621
Iq and Id controllers, 2-635
Kp_n/Tn_n adaptation, 2-624
Speed control configuration, 2-630
Speed controller, 2-623
Table of contents, 2-620
Torque setpoint, 2-625