User Manual

Index
C-816
© Siemens AG 2009 - 2013 All Rights Reserved
SINAMICS G120 CU240B/E-2 Control Units List Manual (LH11), 01/2013
Function diagrams, vector control
Current setpoint filter, 2-634
Current/power/torque limits
, 2-633
Display signals, 2-642
Field weakening characteristic, Id setpoint
(ASM, p0300 = 1), 2-637
Field weakening controller (PEM,
p0300 = 2), 2-639
Field weakening controller, flux controller
(ASM, p0300 = 1), 2-638
Flux controller configuration, 2-631
Id setpoint (PEM, p0300 = 2), 2-636
Interface to the Power Module
(ASM, p0300 = 1), 2-640
Interface to the Power Module
(PEM, p0300 = 2xx), 2-641
Iq and Id controllers, 2-635
Kp_n/Tn_n adaptation, 2-624
Pre-control balancing, acceleration mod-
el, 2-622
Resonance damping and slip compensa-
tion (V/f), 2-628
Speed control configuration, 2-630
Speed controller, 2-623
Speed setpoint, droop, 2-621
Torque setpoint, 2-625
Upper/lower torque limit, 2-632
V/f characteristic and voltage boost, 2-627
Vdc_max controller and Vdc_min control-
ler, 2-626
Vdc_max controller and Vdc_min control-
ler (PM230/PM240), 2-629
Fxxxx, 3-698
G
General
about parameters, 1-8
on faults and alarms, 3-694
on function diagrams, 2-525
I
IASC, 3-696
Index
Parameter, 1-9
Index (parameters), 1-17
Input/output terminals, 2-534
Analog inputs, 2-534
Digital inputs, 2-534
Internal control words, 2-570
Internal control/status words, 2-570
J
Jogging, 2-606, 2-609, 2-614
L
Linked parameter, 1-9
List
Abbreviations, B-803
ASCII table, A-802
Binector inputs (BI parameters), 1-503
Binector outputs (BO parameters), 1-508
Command data sets, 1-492
Connector inputs (CI parameters), 1-506
Connector outputs (CO parameters),
1-510
Drive data sets, 1-495
Encoder data sets, 1-502
Fault and alarm messages, 3-703
Message ranges, 3-703
Motor data sets, 1-500
Parameter ranges, 1-19
Parameters for quick commissioning,
1-517
Parameters for write protection and know-
how protection, 1-515
Parameters, all, 1-22
Power unit data sets, 1-502
List of abbreviations, B-803
Load monitoring, 2-671
M
Manufacturer-specific telegrams, 2-551
MDS (Motor Data Set), 1-15
Message buffer, 2-682
Messages, 2-671
Monitoring functions, 2-671
Motorized potentiometer, 2-606, 2-609, 2-669
N
Name
Alarm, 3-699
Fault, 3-699
Number
Alarm, 3-698
Fault, 3-698
Parameter, 1-9
Number range
Alarms, 3-703
Faults, 3-703
Parameter, 1-19
O
OFF1, 3-695
OFF1_DELAYED, 3-695