User Manual

Parameters

Command and drive data sets - overview

1-494

SINAMICS G120 CU240B/E-2 Control Units List Manual (LH11), 01/2013

p2286[0...n] BI: Hold technology controller integrator / Tec_ctr integ stop

p2289[0...n] CI: Technology controller pre-control signal / Tec_ctrl prectrl

p2296[0...n] CI: Technology controller output scaling / Tec_ctrl outp scal

p2297[0...n] CI: Technology controller maximum limit signal source / Tec_ctrMaxLimS_src

p2298[0...n] CI: Technology controller minimum limit signal source / Tec_ctrl min_l s_s

p2299[0...n] CI: Technology controller limit offset / Tech_ctrl lim offs

p3111[0...n] BI: External fault 3 enable / Ext fault 3 enab

p3112[0...n] BI: External fault 3 enable negated / Ext flt 3 enab neg

p3230[0...n] CI: Load monitoring speed actual value / Load monit n_act

p3232[0...n] BI: Load monitoring failure detection / Load_moni fail_det

p3330[0...n] BI: 2/3 wire control command 1 / 2/3 wire cmd 1

p3331[0...n] BI: 2/3 wire control command 2 / 2/3 wire cmd 2

p3332[0...n] BI: 2/3 wire control command 3 / 2/3 wire cmd 3