User Manual

ManualsBrandsSiemens ManualsVariable Speed DriveSINAMICS G120 CU240B/E-2 Control Units List Manual

381

382

383

384

385

386

387

388

389

390

Parameters

List of parameters

1-388

SINAMICS G120 CU240B/E-2 Control Units List Manual (LH11), 01/2013

Note: Re bit 01:

This bit can be used to execute a control-based ESR.

ESR: Extended Stop and Retract

SAM: Safe Acceleration Monitor (safe acceleration monitoring)

SBR: Safe Brake Ramp (safe brake ramp monitoring)

Description: Displays the crosswise comparison clock cycle.

The value indicates the clock cycle time with which each individual CDC value is compared between the two moni-

toring channels.

Note: CDC: Crosswise Data Comparison

Description: Re index 0:

Displays the message value that resulted in the STOP F on the drive.

Value = 0:

Processor 1 signaled a STOP F.

Value = 1 ... 999:

Number of the incorrect date in the crosswise data comparison between the monitoring channels.

Value >= 1000:

Additional diagnostic values of the drive.

Re index 1:

Displays the value from processor 1 that resulted in the STOP F.

Re index 2:

Displays the value from processor 2 that resulted in the STOP F.

Index: [0] = Message value for CDC

[1] = Processor 1 CDC actual value

[2] = Processor 2 CDC actual value

Dependency: Refer to: C01711

Note: The significance of the individual message values is described in message C01711.

CDC: Crosswise Data Comparison

Re Index 1, 2:

When Safety message C01711 with message value >= 1000 occurs, these indices are not supplied with values.

r9724 SI Motion crosswise comparison clock cycle / SI Mtn CDC clk cyc

PM240

PM250

PM260

CU240E-2_DP_F

CU240E-2_F

CU240E-2_PN_F

Access level: 3 Calculated: - Data type: FloatingPoint32

Can be changed: - Scaling: - Dyn. index: -

Units group: - Unit selection: - Func. diagram: -

Min Max Factory setting

- [ms] - [ms] - [ms]

r9725[0...2] SI Motion diagnostics STOP F / SI Mtn Diag STOP F