User Manual

ManualsBrandsSiemens ManualsVariable Speed DriveSINAMICS G120 CU240B/E-2 Control Units List Manual

361

362

363

364

365

366

367

368

369

370

List of parameters

Parameters

1-365

SINAMICS G120 CU240B/E-2 Control Units List Manual (LH11), 01/2013

Note: The signal source to be searched is set in p9484 (BICO-coded).

The search result is contained in r9482 and r9483 and is specified by the count (r9485) and the first index (r9486).

Description: Sets the enable signals for the safe motion monitoring.

Dependency: Refer to: F01682, F01683

Note: For bit 30 = 1, PROFIsafe telegram 900 must be configured in the F host.

A change only becomes effective after a POWER ON.

F-DI: Failsafe Digital Input

SDI: Safe Direction

SLS: Safely-Limited Speed

SSM: Safe Speed Monitor (safety-relevant feedback signal from the velocity monitoring)

Description: Sets the enable signals for the safe motion monitoring.

Dependency: Refer to: F01682, F01683

Note: For bit 30 = 1, PROFIsafe telegram 900 must be configured in the F host.

A change only becomes effective after a POWER ON.

F-DI: Failsafe Digital Input

SDI: Safe Direction

SLS: Safely-Limited Speed

SSM: Safe Speed Monitor (safety-relevant feedback signal from the velocity monitoring)

p9501 SI Motion enable safety functions (processor 1) / SI Mtn enable P1

PM240

PM250

PM260

CU240E-2_DP_F

CU240E-2_PN_F

Access level: 3 Calculated: - Data type: Unsigned32

Can be changed: C(95) Scaling: - Dyn. index: -

Units group: - Unit selection: - Func. diagram: -

Min Max Factory setting

- - 0000 0000 0000 0000 0000 0000

0000 0000 bin

Bit field: Bit Signal name 1 signal 0 signal FP

00 Enable SI Motion Enable Inhibit -

16 Enable SSM hysteresis and filtering Enable Inhibit 2823

17 Enable SDI Enable Inhibit 2824

30 Enable F-DI in PROFIsafe telegram Enable Inhibit -