User Manual

ManualsBrandsSiemens ManualsVariable Speed DriveSINAMICS G120 CU240B/E-2 Control Units List Manual

List of parameters

Parameters

1-33

SINAMICS G120 CU240B/E-2 Control Units List Manual (LH11), 01/2013

Description: Sets the smoothing time constant for the following display values:

r0063[1], r0068[1], r0080[1], r0082[1].

Description: Displays missing enable signals that are preventing the closed-loop drive control from being commissioned.

Dependency: Refer to: r0002

Note: The value r0046 = 0 indicates that all enable signals for this drive are present.

Bit 00 = 1 (enable signal missing), if:

- the signal source in p0840 is a 0 signal.

- there is a "switching on inhibited".

Bit 01 = 1 (enable signal missing), if:

- the signal source in p0844 or p0845 is a 0 signal.

Bit 02 = 1 (enable signal missing), if:

- the signal source in p0848 or p0849 is a 0 signal.

Bit 03 = 1 (enable signal missing), if:

- the signal source in p0852 is a 0 signal.

Bit 04 =1 (DC brake active) when:

- the signal source in p1230 has a 1 signal

Bit 10 = 1 (enable signal missing), if:

- the signal source in p1140 is a 0 signal.

p0045 Display values smoothing time constant / Disp_val T_smooth

Access level: 3 Calculated: - Data type: FloatingPoint32

Can be changed: U, T Scaling: - Dyn. index: -

Units group: - Unit selection: - Func. diagram: 6714, 8012

Min Max Factory setting

0.00 [ms] 10000.00 [ms] 4.00 [ms]

r0046.0...31 CO/BO: Missing enable sig / Missing enable sig

Access level: 1 Calculated: - Data type: Unsigned32

Can be changed: - Scaling: - Dyn. index: -

Units group: - Unit selection: - Func. diagram: 2634

Min Max Factory setting

- - -

Bit field: Bit Signal name 1 signal 0 signal FP

00 OFF1 enable missing Yes No -

01 OFF2 enable missing Yes No -

02 OFF3 enable missing Yes No -

03 Operation enable missing Yes No -

04 DC braking enable missing Yes No -

10 Ramp-function generator enable missing Yes No -

11 Ramp-function generator start missing Yes No -

12 Setpoint enable missing Yes No -

16 OFF1 enable internal missing Yes No -

17 OFF2 enable internal missing Yes No -

18 OFF3 enable internal missing Yes No -

19 Pulse enable internal missing Yes No -

20 DC braking internal enable missing Yes No -

21 PU enab missing Yes No -

26 Drive inactive or not operational Yes No -

27 De-magnetizing not completed Yes No -

28 Brake open missing Yes No -

30 Speed controller inhibited Yes No -

31 Jog setpoint active Yes No -