User Manual

ManualsBrandsSiemens ManualsVariable Speed DriveSINAMICS G120 CU240B/E-2 Control Units List Manual

321

322

323

324

325

326

327

328

329

330

List of parameters

Parameters

1-321

SINAMICS G120 CU240B/E-2 Control Units List Manual (LH11), 01/2013

Description: Sets the signal source for the enable signal of external fault 3.

External fault 3 is initiated by the following AND logic operation:

- BI: p2108 negated

- BI: p3111

- BI: p3112 negated

Dependency: Refer to: p2108, p3110, p3112

Refer to: F07862

Description: Sets the signal source for the negated enable signal of external fault 3.

External fault 3 is initiated by the following AND logic operation:

- BI: p2108 negated

- BI: p3111

- BI: p3112 negated

Dependency: Refer to: p2108, p3110, p3111

Refer to: F07862

Description: Displays the status of NAMUR signal bit bar.

The faults or alarms are assigned to the appropriate signaling/message classes and influence a specific message

bit.

p3111[0...n] BI: External fault 3 enable / Ext fault 3 enab

Access level: 3 Calculated: - Data type: U32 / Binary

Can be changed: U, T Scaling: - Dyn. index: CDS, p0170

Units group: - Unit selection: - Func. diagram: -

Min Max Factory setting

- - 1

p3112[0...n] BI: External fault 3 enable negated / Ext flt 3 enab neg

Access level: 3 Calculated: - Data type: U32 / Binary

Can be changed: U, T Scaling: - Dyn. index: CDS, p0170

Units group: - Unit selection: - Func. diagram: -

Min Max Factory setting

- - 0

r3113.0...15 CO/BO: NAMUR message bit bar / NAMUR bit bar

Access level: 3 Calculated: - Data type: Unsigned16

Can be changed: - Scaling: - Dyn. index: -

Units group: - Unit selection: - Func. diagram: -

Min Max Factory setting

- - -

Bit field: Bit Signal name 1 signal 0 signal FP

00 Fault converter information electron-

ics/SW_error

Yes No -

01 Network fault Yes No -

02 DC link overvoltage Yes No -

03 Fault drive converter power electronics Yes No -

04 Drive converter overtemperature Yes No -

05 Ground fault Yes No -

06 Motor overload Yes No -

07 Bus error Yes No -

08 External safety-relevant shutdown Yes No -

10 Error communication internal Yes No -

11 Fault infeed Yes No -

15 Other faults Yes No -