User Manual

Overview of parameters

Parameters

1-11

SINAMICS G120 CU240B/E-2 Control Units List Manual (LH11), 01/2013

CU/PM variants

Indicates for which Control Units (CU) and/or Power Modules (PM) the parameter

is valid. If no CU or PM is listed, then the parameter is valid for all variants.

The following information relating to "CU" and "PM" can be displayed under the

parameter number:

Access level

Specifies the minimum access level required to be able to display and change the

relevant parameter. The required access level can be set using p0003.

The system uses the following access levels:

• 1: Standard (not adjustable, included in p0003 = 3)

• 2: Extended (not adjustable, included in p0003 = 3)

• 3: Expert

• 4: Service

Parameters with this access level are password protected.

Table 1-1 Information in the "CU/PM variants" field

CU/PM variants Meaning

All Control Units have this parameter.

CU240B-2 CU240B-2

CU240B-2_DP CU240B-2 with PROFIBUS interface

CU240E-2 CU240E-2

CU240E-2_DP CU240E-2 with PROFIBUS interface

CU240E-2_DP_F

CU240E-2 with PROFIBUS interface and extended integrated

safety functions

CU240E-2_F CU240E-2 with extended integrated safety functions

CU240E-2_PN CU240E-2 with PROFINET interface

CU240E-2_PN_F CU240E-2 with PROFINET interface and extended integrated

safety functions

PM230 Power Module for pumps and fans (3 AC 400 V)

PM240 Power Module for standard applications with dynamic braking

(3 AC 400 V)

PM250 Power Module (3 AC 400 V with energy recovery)

PM260 Power Module (3 AC 690 V with energy recovery)

Note:

Parameter p0003 is CU-specific (available on the Control Unit).

A higher access level will also include the functions of the lower levels.