Technical data

CU230P-2 Control Units, Getting Started
A5E02484096, 05/2009
15
4.1.3 Creating a STARTER project
Create a STARTER project using the Project Wizards
Start the Wizards (Project/New
with wizard) and search, as
shown in the adjacent diagram,
for the inverters connected to
the PC.
In the next window (not shown
here), enter a descriptive
project name and if required,
also a comment.
Click on "Next" and the
adjacent dialog box is
displayed from where you can
configure the PC interface.
Setting the PC interface
If the Access Point "S7ONLINE
(STEP7)" is connected to "PC
COM-Port (USS)" (①), then
you can continue with the
following section. Otherwise,
install the "PC COM-Port
interface" as it is described in
Section
Installing the COM
interface (Page
30).