User Manual

2 Parameters

2.2 List of parameters

SINAMICS G120 CU230P-2 Control Units

426 List Manual, 04/2018, A5E33838102

Value: 0: No function

1: Reserved

2: Activate and save configuration

3: Delete configuration

Dependency: Refer to: p8920, p8921, p8922, p8923, p8924

Notice: When the DHCP mode is active (p8924 > 0), then PROFINET communication via this interface is no longer possible!

However, the interface can be used by the STARTER/SCOUT commissioning tool.

Note: For p8925 = 2:

The interface configuration (p8920 and following) is saved and activated after the next POWER ON.

For p8925 = 3:

The factory setting of the interface configuration is loaded after the next POWER ON.

Description: Displays the actual station name for the onboard PROFINET interface on the Control Unit.

Description: Displays the actual IP address for the onboard PROFINET interface on the Control Unit.

Description: Displays the actual default gateway for the onboard PROFINET interface on the Control Unit.

Description: Displays the actual subnet mask for the onboard PROFINET interface on the Control Unit.

Description: Displays the actual DHCP mode for the onboard PROFINET interface on the Control Unit.

Value: 0: DHCP off

2: DHCP on, identification using MAC address

3: DHCP on, identification via name of station

r8930[0...239] PN Name of Station actual / PN Name Stat act

CU230P-2_PN Access level: 3 Calculated: - Data type: Unsigned8

Can be changed: - Scaling: - Dyn. index: -