User Manual

2 Parameters
2.2 List of parameters
SINAMICS G120 CU230P-2 Control Units
372 List Manual, 04/2018, A5E33838102
Description: Sets the options for the Power Module 330 (PM330).
Description: For service personnel only.
Description: Displays the status word for the drive unit.
Description: Displays the counter reading for modified BICO interconnections on this device.
The counter is incremented by one for each modified BICO interconnection.
p3931 Options for electrical cabinets / Opt elec cabinet
Access level: 3 Calculated: - Data type: Unsigned32
Can be changed: U, T Scaling: - Dyn. index: -
Unit group: - Unit selection: - Func. diagram: -
Min Max Factory setting
- - 0000 0000 0000 0000 bin
Bit field: Bit Signal name 1 signal 0 signal FP
00 Line filter Yes No -
01 Line Harmonics Filter Yes No -
02 du/dt filter compact Voltage Peak Limiter Yes No -
03 Motor reactor Yes No -
04 du/dt filter plus Voltage Peak Limiter Yes No -
05 w/o line reactor Yes No -
07 EmergOff button Yes No -
08 Emergency Stop category 0 Yes No -
09 Emergency Stop category 1 Yes No -
10 Emergency Stop category 1 24 V Yes No -
11 Braking Module (25 kW) Yes No -
12 Braking Module (50 kW) Yes No -
p3950 Service parameter / Serv par
Access level: 3 Calculated: - Data type: Unsigned16
Can be changed: C, U, T Scaling: - Dyn. index: -
Unit group: - Unit selection: - Func. diagram: -
Min Max Factory setting
- - -
r3974 Drive unit status word / Drv_unit ZSW
Access level: 1 Calculated: - Data type: Unsigned32
Can be changed: - Scaling: - Dyn. index: -
Unit group: - Unit selection: - Func. diagram: -
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 Software reset active Yes No -
01 Writing of parameters disabled as
parameter save in progress
Yes No -
02 Writing of parameters disabled as macro is
running
Yes No -
r3978 BICO CounterDevice / BICO CounterDevice
Access level: 4 Calculated: - Data type: Unsigned32
Can be changed: - Scaling: - Dyn. index: -
Unit group: - Unit selection: - Func. diagram: -
Min Max Factory setting
- - -