User Manual

SINAMICS G120 CU230P-2 Control Units

List Manual, 04/2018, A5E33838102

2 Parameters

2.1 Overview of parameters

Access level

Specifies the minimum access level required to be able to display and change the relevant

parameter. The required access level can be set using p0003.

The system uses the following access levels:

• 1: Standard (not adjustable, included in p0003 = 3)

• 2: Extended (not adjustable, included in p0003 = 3)

• 3: Expert

• 4: Service

Parameters with this access level are password protected.

Calculated

Specifies whether the parameter is influenced by automatic calculations.

p0340 determines which calculations are to be performed:

• p0340 = 1 includes the calculations from p0340 = 2, 3, 4, 5.

• p0340 = 2 calculates the motor parameters (p0350 ... p0360, p0625).

• p0340 = 3 includes the calculations from p0340 = 4, 5.

• p0340 = 4 only calculates the controller parameters.

• p0340 = 5 only calculates the controller limits.

PM240 Power Module for standard applications with dynamic braking

PM240

3AC400V

PM240-2

1AC/3AC230 V; 3AC 400V; 3AC 690V

PM240P-2

3AC 400V; 3AC 690V

PM250 Power Module (3 AC 400 V with energy recovery)

PM260 Power Module (3 AC 690 V with energy recovery)

PM330 Power Module for pumps and fans (3 AC 400 V; 3 AC 690 V)

Table 2-1 Information in the "CU/PM variants" field, continued

CU/PM variants Meaning

Note

Parameter p0003 is CU-specific (belongs to the Control Unit).

A higher access level will also include the functions of the lower levels.

Note

For p3900 > 0, p0340 = 1 is also called automatically.

After p1900 = 1, 2, p0340 = 3 is also called automatically.