User Manual

A.2.1 Changing settings using BOP-2
Changing settings using BOP-2
You can modify the settings of your inverter by changing the values of the its parameters. The
inverter only permits changes to "write" parameters. Write parameters begin with a "P", e.g.
P45.
The value of a read-only parameter cannot be changed. Read-only parameters begin with an
"r", for example: r2.
The inverter retentively saves all the changes made using the BOP-2 so that they are protected
against power failure.
Procedure
2.
(6&
2.
2.2.
2.
3
  
  3
  
 
3
  
 
3$5$06
67$1'$5'
),/7(5
(;3(57
),/7(5
U
 





1. Select the menu to display and change parameters.
Press the OK key.
2. Select the parameter filter using the arrow keys.
Press the OK key.
– STANDARD: The inverter only displays the most important parameters.
– EXPERT: The inverter displays all of the parameters.
3. Select the required number of a write parameter using the arrow keys.
Press the OK key.
4. Select the value of the write parameter using the arrow keys.
Accept the value with the OK key.
You have now changed a write parameter using the BOP-2.
❒
Appendix
A.2 Handling the BOP 2 operator panel
Converter with the CU230P-2 Control Units
530 Operating Instructions, 04/2018, FW V4.7 SP10, A5E34257946B AF