User Manual

Function SINAMICS
G120 G120D
*0
*&
&83
&8%
&8(
&86
&8'
&8'
(7SUR)&
23 Expansion of the temperature sensors to include DIN-Ni1000 for analog
inputs AI 2 and AI 3
- - ✓ - - - - - -
24 Communication via AS-Interface.
Default setting of the communication via AS-i: p0015 macros 30, 31, 32
and 34
✓ - - - - - - - -
25 Communication expansion via Modbus:
Adjustable parity bit, access to parameters and analog inputs
✓ ✓ ✓ ✓ ✓ ✓ - - -
26 Extending communication via BACnet:
Access to parameters and analog inputs
- - ✓ - - - - - -
27 The bus error LED for communication via USS and Modbus can be switch‐
ed off
✓ ✓ ✓ ✓ ✓ ✓ - - -
28 Default of the minimum speed to 20% of the rated motor speed - - ✓ - - - - - -
29 For commissioning with an operator panel, the inverter automatically backs
up the measured data retentively in the ROM after identification of the motor
data.
✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓
30 The result of the energy savings calculation for flow machines is available
as a connector
✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓
31 New "ppm" unit (parts per million) for unit switching ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓
32 Displaying speeds during commissioning via operator panel in units of Hz
instead of rpm. Conversion from Hz to rpm via p8552
- - ✓ - - - - - -
33 Voltage-dependent current limit for 600V devices of Power Module PM330
and PM240-2
- - ✓ ✓ ✓ ✓ - - -
Appendix
A.1 New and extended functions
Converter with the CU230P-2 Control Units
524 Operating Instructions, 04/2018, FW V4.7 SP10, A5E34257946B AF