User Manual
A.1.2 Firmware version 4.7 SP9
Table A-2 New functions and function changes in firmware 4.7 SP9
Function SINAMICS
G120 G120D
*0
*&
&83
&8%
&8(
&86
&8'
&8'
(7SUR)&
1 Support of PM240‑2 FSG Power Modules - - ✓ ✓ ✓ ✓ - - -
2 Support of PM240‑2 Power Modules in push-through technology, frame
sizes FSD … FSF, for the following voltages:
● 3 AC 200 V … 240 V
● 3 AC 380 V … 480 V
● 3 AC 500 V … 690 V
- - ✓ ✓ ✓ ✓ - - -
3 Shortened switch-on time for PM330 Power Modules - - ✓ - - - - - -
4 Expansion of the support for 1FP1 synchronous-reluctance motor with the
following inverters:
● SINAMICS G110M
● SINAMICS G120D
● SINAMICS G120 with CU240B‑2 or CU240E‑2 Control Unit
A PM240‑2 Power Module is required to operate a 1FP1 synchronous-re‐
luctance motor with SINAMICS G120
✓ - ✓ ✓ ✓ - ✓ - -
5 Support of 1FP3 synchronous-reluctance motors
A PM240‑2 Power Module is required to operate a 1FP3 synchronous-re‐
luctance motor along with a selective release from SIEMENS
- - ✓ - - - - - -
6 Support of 1LE5 induction motors - ✓ ✓ ✓ ✓ ✓ - - -
7 The inverter supports forming of the PM330 Power Module DC link capac‐
itors
- - ✓ - - - - - -
8 Setting option for two output reactors using parameter p0235 at the SI‐
NAMICS G120C and SINAMICS G120 with PM240-2 FSD … FSF Power
Module
- ✓ ✓ ✓ ✓ ✓ - - -
9 Efficiency-optimized operation of induction motors
Improved method "Efficiency optimization 2"
✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓
10 New setting option for the "Technology application" p0500 = 5 during quick
commissioning
✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓
11 Expansion of the available PROFIdrive telegrams in the SINAMICS G120C
to include telegram 350
- ✓ ✓ ✓ ✓ ✓ - - -
12 An SSI encoder can be parameterized as motor encoder - - - - - ✓ - ✓ -
13 Expansion of the "Basic positioner" function to include the feedback signal
from traversing blocks to the higher-level control system
- - - - - ✓ - ✓ -
Appendix
A.1 New and extended functions
Converter with the CU230P-2 Control Units
Operating Instructions, 04/2018, FW V4.7 SP10, A5E34257946B AF 519