User Manual
Appendix
A
A.1 New and extended functions
A.1.1 Firmware version 4.7 SP10
Table A-1 New functions and function changes in firmware 4.7 SP10
Function SINAMICS
G120 G120D
*0
*&
&83
&8%
&8(
&86
&8'
&8'
(7SUR)&
1 New parameter r7844 [1] for displaying the firmware version in plain text.
"04070901" is equivalent to firmware version V4.7 SP9 HF1, for example
✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓
2 Modbus RTU
● The factory setting of parameter p2040 was increased to provide more
robust inverter operation. Monitoring time for data failure at the Modbus
interface: p2040 = 10 s
● r2057 indicates how the address switch on the inverter is set
✓ ✓ ✓ ✓ ✓ ✓ - - -
3 BACnet MS/TP:
● New factory setting for more robust inverter operation:
– Baud rate p2020 = 38.4 kBd
– Monitoring time for data failure at the BACnet interface was
increased: p2040 = 10 s
– Factory setting for the maximum number of info frames p2025 [1] = 5
– Factory setting for the maximum number of master addresses
p2025 [3] = 32
● r2057 indicates how the address switch on the inverter is set
- - ✓ - - - - - -
4 Further technological unit kg/cm² for unit switchover ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓ ✓
Converter with the CU230P-2 Control Units
Operating Instructions, 04/2018, FW V4.7 SP10, A5E34257946B AF 517