User Manual

4. Press the "Accessible nodes" button.
5. When the USB interface is appropriately set, then the "Accessible nodes" screen form
shows the inverters that can be accessed.

If you have not correctly set the USB interface, then the following "No additional nodes
found" message is displayed. In this case, follow the description below.
6. Transfer the inverter into the project using the menu: "Online - Upload device as new station
(hardware and software)".
You have transferred an inverter accessible via the USB interface into your project.
❒
Commissioning
5.5 Quick commissioning with a PC
Converter with the CU230P-2 Control Units
Operating Instructions, 04/2018, FW V4.7 SP10, A5E34257946B AF 181